Installation instructions
Installation instructions
You will need the following tools :
- 1 bottle spray with soap water
- 1 glass scraper
- 1 squeegee
- 1 cutter
- Some kitchen roll
|
Clean the surface thoroughly using the scraper, the squeegee and the spray with water. Then wipe it with kitchen roll. |
|
Reverse the film and stick the adhesive side of it to the window |
|
Cut the film using the cutter to the size 2-3 cm bigger than the size of the window. |
|
Spray the film with water in order to allow gliding the squeegee along the window. |
|
In order to detach the protective layer, use two pieces of Scotch tape. |
|
Begin at the top, and glide the squeegee from the central part towards the edges. |
|
Detach the protective layer hydrating the adhesive side with soap water. |
|
Cut the film again, now to the size 2mm smaller than the window so it does not touch the frame, and glide with the squeegee once more. |